Apply the waterproofing membrane to clean, dry surfaces with a brush or a roller. For better adhesion, prime the surface with a waterproofing primer. Fill cracks and joints; irregularities over 5 mm must be leveled out. The surface must be free of water droplets.
- Apply at a substrate and air temperature of +5°C to +35°C and a material temperature of +20°C to +25°C.
- Apply at least two thin coats, the second at right angles to the first. Each coat must be no more than 0.5 mm thick. The waterproofing properties, strength and adhesion develop only after the material has dried completely.
- Seal the joints between adjoining surfaces with a suitable waterproofing tape.
- Tiling can start no earlier than 12 hours after the last coat of waterproofing. Use a C1 or C2 cementitious tile adhesive (EN 12004), depending on the type and format of the tile.
- Keep the container tightly closed during breaks in work.
- Clean tools and soiled surfaces with water immediately after use; cured material can only be removed mechanically.
Important! Do not use where the coating is in permanent contact with water (wells, swimming pools, fountains). Do not apply at high humidity (>70%). The material is ready to use, do not thin it with water: this can cause loss of adhesion and cracking.
