- Apply at a temperature of +5°C to +25°C.
- Apply to clean, dry surfaces free from grease and dust. One of the surfaces must be porous. On porous materials a slightly damp surface is acceptable.
- Cut off the tip of the cartridge above the thread, screw on the nozzle, remove the cap and cut the nozzle at a 45° angle to the desired bead size.
- Use a caulking gun to dispense the adhesive.
- Apply the adhesive in beads or dots spaced 10-20 cm apart.
- Apply the adhesive to one of the surfaces, bring the surfaces to be bonded together and press them firmly.
- If the part is positioned incorrectly, do not pull it off, correct its position by sliding it.
- Do not leave the cartridge open for more than 20 minutes. Tack-free time is 1 hour; the part can be repositioned within 30 minutes; full strength is reached after 48 hours at 23°C and 50% relative humidity.
- Remove excess uncured adhesive with a damp cloth. Clean tools with water, hands with soap and water.
- Cured adhesive can only be removed mechanically.
Important! Do not use in joints that are permanently under water. Do not apply at ambient temperatures below +5°C or at high humidity (>70%).
