- The surface to be repaired must be clean, dry and degreased. For better adhesion, use sandpaper to roughen the surface.
- Unpack the tubes and open them by piercing with the back of the cap.
- Dispense equal parts from each tube. You can use the transparent part of the blister pack as a mixing container.
- Mix well with the spatula for 2-3 minutes to a smooth paste.
- Apply the mixture to both surfaces and press. Bonding sets 5 minutes after application. Usable strength is reached after 24 hours.
At low temperatures the curing time is extended. It is not recommended for use at temperatures above 100°C. Not for bonding polypropylene and polyethylene.
Warning! Do not use the product for repairing kitchen utensils that are in direct contact with food!
Note: If the product has hardened as a result of long storage (more than 24 months) or sudden temperature changes, heat it up to +60°C before use. For this purpose use heating radiators, hot water, etc. Allow the product to cool down a little and it will have its original properties again.












